Tabla de contenido
Idiomas disponibles
Idiomas disponibles
This manual is designed to make it as easy as possible for you to assemble,
Tools Needed for Assembly
(Not Included)
• One Phillips head screwdriver
• One ¼˝ blade screwdriver
WARNING
!
Before assembling your ceiling fan, refer to section
on proper method of wiring your fan (page 10). If you
feel you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been
completed and will be helpful in finding your place should you be interrupted.
Do not install or use fan if any part is damaged or missing. This product is designed to use only those parts supplied with
this product and/or any accessories designated specifically for use with this product by Fanimation. Substitution of parts
or accessories not designated for use with this product by Fanimation could result in personal injury or property damage.
Contact your retail store for missing or damaged parts.
1. Check to see that you have received the following parts:
NOTE: If you are uncertain of part description, refer to exploded view illustration.
Hanger Bracket
Assembly (1)
Downrod/Hanger Ball Assembly (1)
– Downrod (1)
– Hairpin Clip (1)
– Hanger Ball (1)
– Clevis Pin (1)
– Set Screw (1)
– Pin (1)
Ceiling Canopy (1)
Hardware Bags
3/16˝-24
Fiber Washers,
Washer Head
3/16˝ (16)
Screws (16)
install, operate and maintain your ceiling fan
• One stepladder
• One wire stripper
Unpacking Instructions
Canopy Screw
Cover Assembly (1)
Motor Coupling
Cover Assembly (1)
Motor Assembly (1)
1/4˝-20
Pan Head Screws
with lock washers (11)
iring outlet o and o connectors
re uired y the local code
conductor
nstalled
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are
missing contact your local retailer.
WARNING
Light Plate Assembly (1)
Light Kit/Glass
Assembly
(1)
Safety Cable Kit
Wire
Safety Cable
Connectors (4)
(1)
4
Materials
he
ini u
wire with ground of the following si e:
ire ength
p to
ft
ft
12V 23A
Hand-held Remote (1)
Wall Holder (1)
Screws (2)
Battery (1)
Blade Holder Set (1)
Flat Washer,
Cable Clamp
Stainless Steel
(1)
(1)
ust e of type
wire would e a
ire i e
Receiver (1)
Wire Connectors (6)
Blade Set (1)
Lag Bolt
(1)
Capítulos
Tabla de contenido
Solución de problemas
