This Manual Is Designed to Make it as Easy as Possible for You to Assemble,
Install, Operate and Maintain Your Ceiling Fan
Tools Needed for Assembly
• One Phillips head screwdriver
• One stepladder
• Three wire connectors (supplied)
WARNING
Before assembling your ceiling fan, refer to section
on proper method of wiring your fan (page 4). If you
feel you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.
For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check
mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should
you be interrupted.
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any
accessories designated specifically for use with this
product by Fanimation. Substitution of parts or
accessories not designated for use with this product
by Fanimation could result in personal injury or
property damage.
1. Check to see that you have received the following parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration.
Fan Motor
Assembly
Ceiling
Canopy
Socket Plate
Assembly
• One wire stripper
Wiring outlet box and box connectors must be of type
• One 1/4" blade
required by the local code. The minimum wire would be a
3-conductor (2-wire with ground) of the following size:
screwdriver
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are
missing contact your local retailer.
Unpacking Instructions
• Fan Motor Assembly
• Hanger Bracket Assembly
• Downrod/Hanger Ball Assembly
• Ceiling Canopy
• Canopy Screw Cover Assembly
• Motor Coupling Cover Assembly
• Blade Holder Cover Set
• Blade Holder Set
• Socket Plate Assembly
• Light Plate Assembly
• 35W Minican Light Bulb (2)
• 100W Minican Light Bulb
• Glass
• Remote Control
Hanger Bracket
Assembly
Light Plate
Assembly
Blade Holder Cover Set
Blade Holder Set
3
Materials
Installed Wire Length
Up to 50 ft.
50-100 ft.
Canopy Screw
Cover Assembly
Downrod/
Hanger Ball
Assembly
Motor Coupling
100-WATT
Cover
Minican
Light Bulb
Glass
Wire Size A.W.G.
14
12
• Hardware bags:
– Eleven 3/16-24 x 10 mm
(blade to blade holder)
Phillips Head Screw
– Eleven 1/4"-20 x 14mm
(blade arm to motor)
Pan Head Screw
– Phillips Screwdriver, 4"
– Three Wire Connectors
– Balance Kit
– Wrench Hex "L" 4 mm
– Bag Assembly Safety Cable
TR31
Remote Hand Held
35-WATT
Minican
Light Bulb (2)
Hardware Bag