Control Panel - Schumacher Electric SLI2 Manual Del Usuario

4.7 For a positive-grounded vehicle, connect
the NEGATIVE (BLACK) clamp from the
Power Pack to the NEGATIVE (NEG, N, -)
ungrounded post of the battery. Connect
the POSITIVE (RED) clamp to the vehicle
chassis or engine block away from the
battery. Do not connect the clamp to the
carburetor, fuel lines or sheet-metal body
5. FEATURES
7
6
5
4
3
2
1
1. 12V 3-pin socket for recharging
2. 12V DC port
3. USB ports
4. Battery clamps
5. 12V/USB/Language button
6. Charging LED indicator

6. CONTROL PANEL

DIGITAL DISPLAY
When the clamps are connected to a
vehicle's battery, the digital display indicates
the battery's voltage. When not connected
to a battery, the digital display is used to
indicate the percent of charge of the jump
starter's internal battery. See Display
Messages for a complete list of messages.
SLI2
8
parts. Connect to a heavy gauge metal
part of the frame or engine block.
4.8 When disconnecting the unit, press the
jump start button to turn off, remove
the clamp from the vehicle chassis,
then remove the clamp from the battery
terminal.
9
10
11
Plug
types
C PLUG
7. Digital display
8. Jump Start button
9. 230V/50Hz charger
10. 12V DC car charger
11. 12V port adaptor
NOTE: If the vehicle's battery voltage is
too low to detect, the display will remain
blank; the voltage will not display. A manual
start procedure is required to enable
the jump start function. See Section 8.2,
Starting a Battery with Low Voltage.
NOTE: During charging, the display will
go into sleep mode and will not display
any messages. To turn the display back
on, press any button.
• 4 •
G PLUG I PLUG