Tabla de contenido
Idiomas disponibles
Idiomas disponibles
•
If the ring terminals were installed incorrectly, an audio alarm will sound.
DO NOT turn your IP-180KE on. This could cause serious damage. Re-
verse ring terminal connections and the audio alarm will stop.
•
If no audio alarm is sounded, turn ON the Jump Start switch and then
crank the engine. If the engine does not start within 5-8 seconds, stop
cranking and wait at least 1 minute before attempting to start vehicle
again. (This permits the battery to cool down.)
•
After the engine starts, make sure to turn OFF the Jump Start switch.
•
Disconnect Quick Connector.
5.
CONTROL PANEL
6.
LED INDICATORS
6.1
To check the internal battery's charge status, press the Battery Status But-
ton on the front of the Instant Power™.
6.2
The
LED lights will indicate the charge level as follows:
•
A red LED indicates a 50% or less charge and you should immediately
recharge the Instant Power™.
•
A yellow LED indicates a 50 to 75% charge. The Instant Power™ may be
used but should be recharged as soon as possible.
•
A green LED indicates the internal battery is fully charged.
7.
CHARGING OF INTERNAL BATTERY WITH BUILT-IN CHARGER
7.1
After removing the Instant Power™ from the carton, charge it for a mini-
mum of 8 hours before using, even if the green charged LED glows.
NOTE: The ON/OFF switch should be in the OFF position to recharge the
internal battery.
(R
,
ed
yellow and gReen lights
3
•
•
)
Tabla de contenido
