Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Collar
3. Connect the Supplies
Tighten the nuts on each valve body from underneath the
deck/rim.
Solder the copper tubes to the valve bodies and diverter.
Solder the spout supply tube (not shown) to the diverter.
If desired, install water hammer arrestors (not supplied) in the
hot and cold water tubes near the valve bodies (not shown).
Solder the hot and cold water tubes to the valve body inlets (not
shown). Make sure that the cold supply is on the right side.
1054252-2-B
Solder copper
Nut
tubes.
6
Kohler Co.
Tabla de contenido
