Information Requirements For Electric Local Space Heaters - UFESA RD500M Manual De Instrucciones

Ocultar thumbs

Contenido

página de 57

/ 57
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

Unplug the product immediately from the mains in the event of any breakdown or damage and contact an

official technical support service. In order to prevent any risk of danger, do not open the device. Only qualified

technical personnel from the brand´s Official technical support service may carry out repairs or procedures

on the device.

B&B TRENDS SL. disclaims all liability for damages that may occur to people, animals or objects, for the non-

observance of these warnings.

INSTALLATION

Your appliance shall be used as portable appliance only (thanks to respect all the safety warnings given below)

Put the heater on a flat, dry and clean surface.

Install the standing feet with wheels provided with product.

Warning: Always use your appliance with rollers fixed.

ASSEMBLY OF THE HEATER

Fit the separate foot to the radiator by pushing it firmly onto the control panel and end fin. Check the stability

of the heater by standing it on a smooth level surface.

Fitting the foot to the Heater

INSTRUCTIONS FOR USE

OPERATION OF THE HEATER

NOTE 1: - When the heater is turned on for the first time or after having not been used for a long period, it may emit

some smell and fumes. These will disappear when the heater has been on a short while.

1) Choose a suitable location for the heater, taking into account the safety instructions above.

2) Insert the plug of the heater into a suitable socket.

3) Turn the thermostat knob fully in a clockwise direction to the maximum setting.

4) Turn on the heating element by means of the rocker switch on the side panel. When the heating element is on

the power switch will illuminate.

5) When the desired room temperature has been reached, the thermostat knob should be turned slowly anti-

clockwise until the thermostat is heard to click off and the light on the power switch is seen to go out. After this the

heater will keep the air temperature in the room at the set temperature by switching on and off automatically.