Troubleshooting Guide; Information Requirements For Electric Local Space Heaters - UFESA Scuti Manual De Instrucciones

the warmer will change the direction within the scope of 60 degrees.
· Using method for remote-control type
1. "ON/1/2/3" button controls the heating power, continuous press of such key will cause the
warmer to have cycled change with its power.
2. "Oscillate" button controls the oscillating, the warmer can shake left and right for one press
and stop for another press.
3. "Standby" button controls the working state of the warmer.
4. "Timer" button controls the warmer to have random timing within 0.5h to 7.5h and it may
increase by 0.5h for each press, shown by indicators on the control panel. If all indicators on
the panel are off, it means the warmer under continuous working.
Users are allowed to operate either on the control panel or by the remote controller.
Technical parameters are subject to change without notice. All images are for illustration pur-
pose only.

TROUBLESHOOTING GUIDE

Possible operating anomalies
INCIDENT
The device
does not
work.

Information requirements for electric local space heaters

Scuti
Item
Heat output
Nominal heat
output
Minimum heat
output
(indicative)
Maximum
continuous
heat output
Auxiliary electricity
consumption
18
CAUSE
Appliance not switched on.
The unit is on but the selected
temperature level in the thermostat is
lower than the temperature of the room.
Symbol Value
P nom 1,2
P min 0,4
P max,c 1,2
Unit Item
Type of heat input, for electric
storage local space heaters only
Manual heat charge control,
KW
with integrated thermostat
Manual heat charge control
KW with room and/or outdoor
temperature feedback
Electronic heat charge control
KW with room and/or outdoor
temperature feedback
Fan assisted heat output
SOLUTION
Switch on the appliance
using the speed button.
Increase the temperature
level of the thermostat
(D)
Unit
No
No
No
No