Luminance Brands Kathy Ireland Home SUMMER NIGHT CF652BQ01 El Manual Del Propietario página 6

3. Ceiling Fan Assembly
3.4
Loosen the Two Set Screws in the Motor Coupler.
Place the Hanger Ball/3.5" Downrod Assembly into the Motor
Coupler, aligning the Clevis Pin Holes in the Downrod with the
Holes in the Motor Coupler (Figure 3).
The Clevis Pin MUST go through the Holes in the Motor
Coupler and the Holes in the Downrod.
Be sure to push the straight leg of the Hairpin Clip through the
Hole near the end of the Clevis Pin until the curved portion of
the Hairpin Clip snaps around the Clevis Pin.
The Hairpin Clip must be properly installed to prevent the
Clevis Pin from working loose.
Pull on the Hanger Ball to make sure the Clevis Pin is properly
installed.
WARNING
!
It is critical that the clevis pin in the Motor Coupler
is properly installed. Failure to verify that the pin is
properly installed could result in the fan falling.
3.5
While pulling up on the Hanger Ball, retighten the Two Set
Screws (previously loosened) in the Motor Coupler to secure
the Hanger Ball/3.5" Downrod Assembly into place (Figure 4).
NOTE: The set screws must be properly installed as
described above, or fan wobble could result.
WARNING
!
It is critical that the set screws are securely tightened.
Failure to verify that the set screws are properly
installed could result in the fan falling.
(Continued)
DOWNROD
CLEVIS
PIN
MOTOR
COUPLER
Figure 3
MOTOR COUPLER
SET SCREW
Figure 4
6
HAIRPIN
CLIP
CLEVIS
PIN
HAIRPIN
CLIP
SET SCREW
U.L. Model No.: CF652