Connecting The Ac Power Cord - Eiki LC-X85 Guía De Referencia Rápida

The AC Power Cord supplied with this projector meets the requirement for use in the country you purchased it.
AC Power Cord for the United States and Canada:
AC Power Cord used in the United States and Canada is listed by the Underwriters Laboratories (UL)
and certified by the Canadian Standard Association (CSA).
AC Power Cord has a grounding-type AC line plug. This is a safety feature to be sure that the plug
will fit into the power outlet. Do not try to defeat this safety feature. Should you be unable to insert
the plug into the outlet, contact your electrician.
AC Power Cord for the United Kingdom:
This cord is already fitted with a moulded plug incorporating a fuse, the value of which is indicated on the pin face of the plug.
Should the fuse need to be replaced, an ASTA approved BS 1362 fuse must be used of the same rating, marked thus
the fuse cover is detachable, never use the plug with the cover omitted. If a replacement fuse cover is required,
ensure it is of the same colour as that visible on the pin face of the plug (i.e. red or orange). Fuse covers are available from
the Parts Department indicated in your User Instructions. If the plug supplied is not suitable for your socket outlet, it should
be cut off and destroyed. The end of the flexible cord should be suitably prepared and the correct plug fitted.
WARNING: A PLUG WITH BARED FLEXIBLE CORD IS HAZARDOUS IF ENGAGED IN A LIVE SOCKET
OUTLET.
The Wires in this mains lead are coloured in accordance with the following code:
Green-and-yellow ············ Earth
Blue ································· Neutral
Brown ······························ Live
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the
terminals in your plug proceed as follows:
The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked by the letter E or
by the safety earth symbol
The wire which is coloured
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.
WARNING: THIS APPARATUS MUST BE EARTHED.

Connecting the AC Power Cord

This projector uses nominal input voltages of 100–120 V or
200–240 V AC.
CAUTION
The AC outlet must be near this equipment and must be
easily accessible.
NOTE ON THE POWER CORD
AC power cord must meet the requirements of the country where you use the projector.
Confirm the AC plug type with the chart below and proper AC power cord must be used.
Projector side
To POWER CORD
CONNECTOR on your
projector.
AC Power Cord Requirement
or coloured green or green-and-yellow.
blue must be connected to the terminal which is marked with the letter N or coloured black.
AC outlet side
For the U.S.A. and Canada
Ground
To the AC Outlet.
(120 V AC)
Connect the AC power cord (supplied) to the
projector.
For Continental Europe
To the AC Outlet.
(200–240 V AC)
- 6 -
GROUND
. If
ASA
For the U.K.
To the AC Outlet.
(200–240 V AC)