Maintenance And Troubleshooting; Meter Maintenance; Changing The Batteries - Accu-Chek Nano Manual Del Usuario

7

Maintenance and Troubleshooting

Meter Maintenance

The meter automatically tests its own systems every time you turn it on and lets you know if something is
wrong. See Chapter 7, Display and Error Messages.
If you have problems with the meter or think the results are not accurate, perform a control test with an
unexpired test strip and control solution. If the control result is not within the acceptable range, contact the
Accu-Chek Customer Care Service Center at 1-800-858-8072.

Changing the Batteries

1
Use your thumb to slide
the battery drawer out of
the meter.
NOTE
• The meter uses two 3-volt batteries, coin cell type CR2032. This type of battery can be found in many
stores. It is a good idea to have spare batteries available.
• Always replace both batteries at the same time and with the same brand.
38
2
Remove the old batteries
and place the new ones in
the battery drawer with
the (+) side facing down.
3
Slide the battery drawer
back into position until it
locks into place.