Electromagnetic Fields (Emf); Preparing For Use; Using The Appliance - Philips Aluminium Collection HR1866/30 Manual De Instrucciones

- Only unlock the clamps after you have switched off the appliance and the filter has
stopped rotating.
- Do not remove the pulp container when the appliance is operating.
- Always unplug the appliance after use.

Electromagnetic fields (EMF)

This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientific evidence available today.

preparing for use

1 Wash all detachable parts (see chapter 'Cleaning').
2 Pull the mains cord out of the cord storage compartment at the back of the appliance (Fig. 2).
3 Place the juice collector in the appliance (1). To place the pulp container, tilt it forwards
slightly (2). Insert the top end of the pulp container first and then push home the bottom
end (Fig. 3).
To empty the pulp container while you are juicing, switch off the appliance and carefully remove the
pulp container.
Note: Reassemble the empty pulp container before you continue juicing.
4 Put the filter in the juice collector (1). Hold the lid over the filter and lower it into position
(2) (Fig. 4).
Make sure the filter is fitted securely onto the driving shaft ('click').
Always check the filter before use. If you detect any cracks or damage, do not use the appliance.
Contact the nearest Philips service centre or take the appliance to your dealer.
5 Snap the two clamps onto the lid to lock it into place ('click') (1). Align the groove in the
pusher with the small protrusion on the inside of the feeding tube and slide the pusher into
the feeding tube (2) (Fig. 5).
Make sure the clamps are locked into position on either side of the lid.
6 Put the lid on the juice jug to avoid splattering. Place the juice jug under the spout (Fig. 6).
7 Push the spout downwards before you start juicing.
Note: When the spout is in upward position, it functions as a drip stop when the appliance is switched off.
However, if you leave the spout in upward position during juicing, juice splashes out the spout.

using the appliance

The appliance only functions if all parts are assembled properly and the lid is properly locked in
place with the clamps.
1 Wash the fruit and/or vegetables and cut them into pieces that fit into the feeding
tube. (Fig. 7)
2 Make sure the juice jug is placed under the spout and the spout is in downward position.
3 Turn the control knob to setting 1 (low speed ) or 2 (normal speed) to switch on the
appliance. (Fig. 8)
4 Put the pre-cut pieces in the feeding tube and gently press them down towards the rotating
filter with the pusher (Fig. 9).
Do not exert too much pressure on the pusher, as this could affect the quality of the end result. It
could even cause the filter to come to a halt.
4222_005_0074_2_DFU-Booklet_A5_v1.indd 7
EnglisH
7
21-10-11 11:42