LEMKEN -EPS Instrucciones De Servicio página 16

Transport position (with Uni-wheel, only)
=>
Set lock pin of the centre locking device being provided in front of
the headstock to locking position, lift plough completely and press
function button (6) afterwards..
The plough will be turned into transport position and locked.
Cancelling of not stored adjustment data
=>
Entered data being not stored, will be cancelled by means of
pressing the RQ-button (16).
Quick motion of the operation sequences
=>
When the operation sequences shall follow quickly, additionally to
the corresponding function button the Q-button (17) must be
pressed.
Storing adjustment data
By means of pressing the Q-button (17) and the M-button (7) at
the same time the shown adjustment data will be encoded.
Adjusting the plough to the stored adjustment data
=>
The plough control will be set to the stored data by means of
pressing the M-button (7).
Indication of the stored adjustment data
=>
The latest stored data will be indicated by pressing the Info-button
(8).
STOP-Function
=>
All function sequences will be stopped by pressing the Stop-button
(9). This button is used as emergency switch!
Switching on and off the plough control
=>
The ON-button (18) must always be pressed to activate the plough
control. When the red light emitting diode is shining, the plough
control is ready to operate.
14