Idiomas disponibles
Idiomas disponibles
ASSEMBLY
WARNING!
There are several areas during the assembly process that special
attention must be paid. It is very important to follow the assembly
instructions correctly and to make sure all parts are firmly tightened. If
the assembly instructions are not followed correctly, the equipment could
have parts that are not tightened and will seem loose and may cause
irritating noises. To prevent damage to the equipment, the assembly
instructions must be reviewed and corrective actions should be taken.
SERIAL NUMBER LOCATION
Before proceeding, find your ascent trainer's serial number located on a barcode
sticker and enter it in the space provided below.
SERIAL NUMBER
MODEL NAME
A30
A50
MATRIX ASCENT TRAINER
F
F
* Use the information above when calling for service.
UNPACKING
Unpack the equipment where you
will be using it. Place the carton on a
level flat surface. It is recommended
that you leave the frame in the
Styrofoam base until instructed. Never
open box when it is on its side.
TOOLS INCLUDED:
F 6 mm Allen Wrench
F 8 mm Allen Wrench
F 10 mm Allen Wrench
F 13/17 mm Flat Wrench
F Phillips Screwdriver
NEED HELP?
If you have questions or if there are any missing parts, contact Customer Tech
Support. Contact information is located on the information card.
IMPORTANT NOTES
During each assembly step, ensure that ALL nuts
and bolts are in place and partially threaded.
Several parts have been pre-lubricated to aid in assembly
and usage. Please do not wipe this off. If you have difficulty,
a light application of lithium grease is recommended.
PARTS INCLUDED:
F 1 Ascent Trainer Frame
F 1 Top Rail Bracket
F 2 Hand Rail Covers
F 1 Pedal Arm Cover Set
F 1 Upper Assembly
F 2 Incline Frame Boots
F 1 Top Cap Front Cover
F 1 Top Cap Rear Cover
F 2 Upper/lower Dual Action Arms
F 2 Link Arm Cover Sets
F 2 Handlebar Caps
F 1 Power Cord
F 1 Hardware Kit
Console sold separately
3
