Installation Of Guide Section Bar; Installation Of Motor On Section Bar - V2 ATRIS-700 Instrucciones

4 - INSTALLATION OF GUIDE SECTION
BAR
1. Remove the section bar from its cardboard packaging and
check its integrity.
2. Open the profile and once laid, slide the joining profile to the
limit position highlighted by two holes
3. Adjust the tension of the chain/belt using the Allen-head
screw with a 10 mm Allen-wrench: turn the bolt until the
chain/belt is sufficiently tight.
m
CAUTION: After tensioning the chain/belt make sure
the drive carriage slides freely throughout the length of the
guide. Eliminate any friction prior to proceeding with the
next phases of installation.
5 - INSTALLATION OF MOTOR
ON SECTION BAR
1. Position the profile on the motor, inserting the shaft of the
motor in the specific compartment on the profile.
2. Verify that the section bar fits snuggly against the motor.
3. Position the two omega brackets on the section bar so that
they correspond with the holes on the base of the motor.
4. Fasten the two omega brackets using the 6 x 15 self-threading
screws provided.
m
In case of lack of space, the motor can be mounted
rotated of 90°
- 29 -