Gauge Installation - Suzuki 34200-96L2 Serie Manual De Instalación

2. Gauge Installation

At first, choose a position where it is visible from the boat steering position and the wiring space on the
back side of the gauge can be secured.
Then install the multi- function gauge using the following procedure.
• GAUGE DIMENSIONS
(1) Make a hole on the gauge install position of the boat precisely.
• Single gauge
If the measurement does not fit to the size of the gauge, the gauge cannot be installed correct-
ly.
Because of this, insufficient water resistance and drop out of the gauge may happen.
(1) Install the gasket (1) to gauge.
(2) Insert the gauge (2) into panel hole.
(3) Thread the nut (3) onto threaded housing of gauge and
tighten to back of panel.
If the water resistant process is not sufficient, water may get into the gauge and cause a trou-
ble.
105 (4.13)
Unit: mm (in.)
86 (3 3/8)
Unit: mm (in.)
16.5
(0.65)
Unit: mm (in.)
• Dual gauge
120 (4.72) minimum
86 (3 3/8)
Unit: mm (in.)
NOTICE
NOTICE
54.9
(2.16)
86 (3 3/8)
1
2
3
17