Preparing The Surface; Setting Up; Assembly/Disassembly; Choosing/Changing The Nozzle - Parkside PFS 400 A1 Traducción Del Manual De Instrucciones Original

NOTE
► Do not exceed the maximal viscosity of the
appliance. The spray material must not be
too thick. Otherwise, the appliance might
clog.
► Ensure that the spray material and thinning
agent are compatible. Using an unsuitable
thinning agent may cause clots that clog the
appliance. Never mix synthetic resin
varnishes with cellulose thinners.
► To find out which thinning agent is suitable for
your spray material (water, paint thinner),
refer to the manufacturer's notes provided
with the spray material.
► Granular products and products containing
solids must not be sprayed. Their abrasive
effect will shorten the service life of the pump
and valve.

Preparing the surface

♦ Carefully cover a large area around the spray
surface. Any surface that is not masked could
become contaminated.
♦ Ensure that the surface is clean, dry and free of
grease.
♦ Polished surfaces should be lightly sanded and
the sanding dust removed.

Setting up

Assembly/disassembly

♦ Move the ▸ mark on the spray unit
mark on the motor unit . Now, turn the spray
unit until the ▸ mark on the spray unit
locks into the mark on the motor unit
♦ Unlock the lock . Turn the ▸ mark on the
5a
spray unit to the
unit to separate the two units.
│ GB │ MT
■ 42
to the
mark on the motor

Choosing/changing the nozzle

Nozzle Use
all types of paints and
1.8 mm nozzle
lacquers
viscous spray material
2.6 mm nozzle
♦ Undo the union nut
it from the spray unit
♦ Fit the desired nozzle
head .
♦ Screw the union nut
unit .

Adding spray material

♦ Unscrew the paint cup
unit .
♦ To work on a horizontal object, place the riser
pipe in front, facing the nozzle head
To work overhead, place the riser pipe
back, facing the motor unit
♦ Fill the paint cup
and screw it firmly onto the spray unit
Switching the appliance on/off
Working methods
♦ Hold the spray gun at a constant distance from
the object. The ideal spraying distance is
approx. 15 cm.
♦ Work out the best settings by carrying out a test.
♦ Do not switch the appliance on/off over the
spray surface. Rather, start/end the spraying
process approx. 10 cm from the spray surface.
Switching on
♦ Insert the plug into a mains power socket.
♦ To switch the appliance on, pull the trigger
and keep it pulled.
Switching off
♦ To stop spraying, simply release the trigger
♦ When you are finished working, disconnect the
plug from the mains power supply.
completely and remove
.
onto the nozzle
back onto the spray
from the spray
in the
.
with the spray material
.
PFS 400 A1
.
.