WAGNER W 670 Manual Del Usuario página 33

W 670
Wood preservatives, mordants, oils, disinfection agents,
plant protective agents
Paints containing solvents and water-soluble paints,
primers, vehicle coating paints, thick-film glazes
2.
If the convey capacity is too low, add 5 - 10 % dilution step-by-step until the convey
capacity fulfils your requirements.
Start-up
Before connecting to the mains supply, be sure that the supply voltage is identical with
the value given on the rating plate.
•
Attach the carrying strap to the unit.
•
Unscrew the container from the spray gun.
•
Aligning suction tube.
If the suction tube is positioned correctly, the container contents can be sprayed
without almost any residue.
When spraying horizontal surfaces, turn suction tube forward. (Fig. 3 A)
When spraying objects overhead, turn suction tube back. (Fig. 3 B)
•
Set the container on a sheet of paper, pour in the prepared coating material and
screw the container tightly onto the spray gun.
•
Connect the front part with the rear part of the gun. (Fig. 5)
•
Mount the air hose (Fig. 4, a + b). Insert the air hose firmly into the connection of the
unit and the gun handle. The position of the hose is not relevant.
•
Insert the spray gun into the gun holder on the unit.
•
Put the machine down only on a level, clean surface. Otherwise, the gun may suck in
dust, etc.
•
Sling on the carrying strap with the unit.
•
Remove the spray gun from the gun holder and point it at the object to be coated.
•
It is advisable to test spray cardboard or a similar material in order to determine the
material quantity and the spray pattern.
•
Press the ON/OFF switch at the device.
Settings on the ON/Off switch
The W670 has a multi-stage On/Off switch. This allows the power of the unit to be adjusted
to the material used, in order to optimise the spray pattern and reduce the spray mist.
Switch in Position "0"
Switch in Position "1"
Switch in Position "2"
for thin materials the spray mist can be reduced and energy saved by
i
switching to speed stage 1.
Thinning recommendation
(fig. 2)
(fig. 3)
 Unit switched off
 Unit switched on to speed stage 1
(for working with very thin materials such as e.g. glazes)
 Unit switched on to speed stage 2
(for working with more viscous materials such as e.g.
lacquers)
GB
undiluted
dilute by 5 - 10 %
27