Wall Mount; Tools Required - Cooper Lighting Lumark Axcent Instrucciones De Instalación

Installation Instructions – Axcent (Small & Large)
INSTALLATION
This lighting fixture has been shipped complete with one
of several mounting options. Please follow the installation
instructions specific to the catalog part that you ordered.
N otee: Care must be taken not to set lighting fixture down
on optical lenses or lift the fixture in the lens area.

Wall Mount

Tools Required

#2 Phillips head screwdriver, torque wrench.
1. Remove the wedge plate by loosening the (2) ¼-20
Phillips head screws on the fixture. (Figure 1.)
2. Attach the wedge plate to the wall or junction box
(Figure 2). Wedge plate must be mounted with
hardware able to support a fixture weight of up to 25 lbs.
N otee: The fixture is fully sealed and does not require any
additional water proofing.
Wall
Wedge Plate
Level Bubble
J-Box Mounted on Wall
Figure 2.
3. Hang the fixture from the wedge plate using the wire
hanger located on the back of the fixture (Figure 4).
Wire hanger can be located by looking for the red flag
label.
4. Make wiring connections per wiring diagram. (Figure 3.)
N otee: Dimming wires will not exit fixture when fixture
is ordered with motion control device. If external
dimming control is not used then cap off gray and
purple wires.
5. Lift the fixture off of the wire hanger and onto wedge
plate. Ensure that the luminaire supply leads are not
pinched between the wedge plate and the housing.
6. Tighten the two ¼-20 Phillips head screws on the
fixture to 20 in-lbs. (Figure 5.)
2
COOPER LIGHTING SOLUTIONS
Junction Box Mounting
(Recommended Wet Location Type
J-Box supplied by others)
IB514031EN Installation instructions
(2X)
Phillips head
-20 Lock Screws
¼
Figure 1.
Wall
Wedge Plate
Level Bubble
J-Box Recessed in Wall
(+) Line
(-) Common
Ground
Dimming Control
0-10V
Figure 3.
3" Axcent Small
5 1/4" Axcent Large
Wedge
Plate
Black
White
Green
Fixture
Gray
Purple