Kichler 60 Zenith Led Manual De Instrucciones página 9

HANGING THE FAN
(continued)
Step 8. Slip the top motor cover, coupling cover, canopy cover and
Downrod
canopy onto the downrod. (Fig. 9)
Canopy
Secure the top motor cover to the motor by using the three top
Canopy cover
motor cover set screws provided, but do not tighten at this time.
Thread the hanger ball onto the downrod, insert the cross pin
Coupling cover
through the downrod and tighten. Now tighten the set screw.
Set screws
Step 9. Lift the motor assembly into position and place the hanger
ball into the ceiling mounting bracket.
Retaining clip
Rotate the entire assembly until the "Check Tab" has dropped into
Hitch pin
the "Registration Slot" and seats firmly. (Fig. 10)
The entire motor assembly should not rotate (left or right) when
seated properly.
WARNING: Failure to reattach the cross pin and seat the "Check Fig. 9
Tab" can cause the fan to fall from the ceiling during operation. Take
special care to make sure this pin is reattached.
Registration slot
Fig. 10
60" ZENITH LED | 9
TM