Installation; Right Place For Installation; Adjusting The Stands - Beko RCNE560E40ZLXPHUN Manual Del Usuario

Installation

4
A
Read the "Safety Instructions" section first!

4.1 Right place for installation

Contact the Authorized Service for the
product's installation. To ready the product
for installation, see the information in the
user guide and make sure the electric and
water utilities are as required. If not, call
an electrician and plumber to arrange the
utilities as necessary.
WARNING: The manufacturer
assumes no responsibility for
B
any damage caused by the work
carried out by unauthorized
persons.
WARNING:
The product's power cable must
B
be unplugged during installation.
Failure to do so may result in death
or serious injuries!
WARNING: If the door span is
too narrow for the product to
pass, remove the door and turn
A
the product sideways; if this does
not work, contact the authorized
service.
• Place the product on a flat surface to
avoid vibration.
• Place the product at least 30 cm
away from the heater, stove and
similar sources of heat and at least 5
cm away from electric ovens.
• Do not expose the product to
direct sunlight or keep in damp
environments.
• The product requires adequate air
circulation to function efficiently.
• If the product will be placed in an
alcove, remember to leave at least
5 cm distance between the product
and the ceiling and the walls.
• Do not install the product in
environments with temperatures
below -5°C.
Refrigerator / User Guide
• Your product requires adequate air
circulation to function efficiently.
If the product will be placed in an
alcove, remember to leave at least 5
cm clearance between the product
and the ceiling, rear wall and the
side walls.
• If the product will be placed in an
alcove, remember to leave at least 5
cm clearance between the product
and the ceiling, rear wall and the
side walls. Check if the rear wall
clearance protection component is
present at its location (if provided
with the product). If the component
is not available, or if it is lost or
fallen, position the product so
that at least 5 cm clearance shall
be left between the rear surface
of the product and the wall of the
room. The clearance at the rear is
important for efficient operation of
the product.

4.2 Adjusting the stands

If the product is not in balanced position,
adjust the front adjustable stands by
rotating right or left.
13/36EN