Installation Of The Wall Bracket; Charging - Silvercrest SAST 18 A1 Instrucciones De Uso

Installation of the wall bracket

DANGER – ELECTRIC SHOCK!
► Ensure that there are no power cables or water pipes in the wall at the
location where you intend to drill the holes for the wall bracket
Drilling into a current-carrying electric cable can be potentially fatal!
1) Select a suitable installation location for the wall bracket
It must be possible to remove the handheld vacuum cleaner easily and there
must be a mains power socket nearby. In addition, there should be no power
or water lines in the wall.
2) Drill two holes below each other at a distance of approx. 110 mm from each
other. The drill holes must be suitable for 5 mm wall plugs.
3) Push in the wall plugs and screw in the screws so that the heads protrude a
few millimetres.
4) Hang the wall bracket
ensure that the screws slide into the slots. The wall bracket
against the wall. You can adjust the distance to the wall and compensate for
any unevenness in the wall by screwing in or unscrewing the screws.
5) Ensure that the power cable is not trapped and that it lies properly in the
cut-out.
6) Push the two accessories holders
and right of the wall bracket
holders
7) Place the barrel plug
from below. Secure the barrel plug
8) Plug the mains adapter

Charging

NOTE
► Check to ensure that the On/Off switch
position "OFF") before starting the charging process.
■ Hang the appliance into the wall bracket
the wall bracket
the barrel plug
charge indicator lamp
■ When charging is complete, which can take around 5 to 5.5 hours with
fully discharged batteries, the charge indicator lamp
The appliance automatically switches to trickle charging. Nevertheless, in
order to avoid possible damage to the batteries, do not leave the appliance
permanently connected to the mains adapter
SAST 18 A1
with the drill holes over the two screws and
. You can place the nozzles in the accessories
.
of the power adapter
into a power socket.
should slide into the recesses on the motor unit
into the socket on the lower end of the motor unit
flashes red and the charging process begins.
into the respective catches on the left
into the wall bracket
by turning it.
has been pushed back (to the
from above. The catches on
lights up green.
.
GB │ IE
.
:
should lie flush
and
. The
│ 27 ■