To Change The Operation Direction Of The Trimmer Head; Automatic Shutdown Function; To Stop The Product - Husqvarna 520iLX Manual Del Usuario

4. Use 80% speed when you cut and clear vegetation.
This decreases the wear on the trimmer head and
trimmer line.
To cut the grass
1. Make sure that the trimmer line is parallel to the
ground when you cut the grass.
2. Do not push the trimmer head to the ground. This
can cause damage to the product.
3. Move the product from side to side when you cut
grass. Use full speed.
To sweep the grass
The airflow from the rotating trimmer cord can be used
to remove cut grass from an area.
1. Hold the trimmer head and its cord parallel to the
ground and above the ground.
2. Apply full throttle.
3. Move the trimmer head from side to side and sweep
the grass.
WARNING: Clean the trimmer head cover
each time you assemble new trimmer cord
to prevent unbalance and vibrations in the
handles. Also do a check of the other parts
of the trimmer head and clean it if
necessary.
To start the SavE function
The product has a power saving function. The SavE
function gives the longest operation time from the
battery.
756 - 001 - 24.10.2018
1. Push the SavE button to start the function. The
green LED comes on to show that the function is on.
2. Push the SavE button again to stop the SavE
function.
To change the operation direction of the
trimmer head
It is possible to change the operation direction of the
trimmer head. This can be done at full speed or at stop
position. In the factory, the trimmer head is set to turn
clockwise. The green LED is off when the trimmer head
turns clockwise.
1. Push the operation direction button to make the
trimmer head turn counterclockwise. The green LED
is on when the trimmer head turns counterclockwise.
Note: It is easier to tap out the trimmer line to make it
longer when the trimmer head turns clockwise.

Automatic shutdown function

The product has a shutdown function that stops the
product if the product is not used. The green LED for
start/stop indication goes off and the product stops after
120 seconds.

To stop the product

1. Release the power trigger or the power trigger
lockout.
2. Push the start/stop button until the green LED is off.
3. Push the release buttons on the battery and pull the
battery out.
13