Changing The Front Film; Ring Tone Selection; Intercom Function - golmar SV-220S Manual De Instalación

44
C
hanging the front film.
The monitor is supplied with a reversible front film, that allow the owner
to choose between two colors.To change the front film, remove
the front plate by inserting a plain screwdriver in the
triangle marks, as it is shown on the drawing.
R
ing tone selection.
It's possible to select for each monitor between four different ring tones.
To select a ring tone:
1. Press the push button
2. Press the push button
desired ring tone.
3. To save the desired ring tone and exit press the push button
The monitor exit of the ring tone selection to the 40 seconds, saving the last selected
ring tone.
I
ntercom function.
Platea-22 monitor, incorporate as standard the intercom function between two monitors of the
same apartment. To enable this function check the following conditions:
.
- The monitor that is connected to door panel(s) has been configurated as master and slave
the other monitor.
- Link the 1, 2 and 3 terminals of the units (see page 45).
.
To stablish an intercom communication lift the handset and press the intercom push button
the calling monitor: acoustic tones will be reproduced on the handset confirming the call is in
progress, the called monitor will receive the call. To establish communication, lift the handset
of the called monitor. To finish the communication, press the push button
monitors. If during an intercom communication a call is made from the door panel, the
intercom function will be cancelled, establishing audio and video communication between
the door panel and the master monitor.
MONITOR INSTALLATION
to play the selected ring tone.
to play the next ring tone. Repeat this stage till find the
.
at any of the
on