Introduction; Índex; Starting Recommendations - golmar SV-220S Manual De Instalación

INTRODUCTION

First of all we would like to thank and congratulate you for the purchase of this product
manufactured by Golmar.
The commitment to reach the satisfaction of our customers is stated through the ISO-9001 certification
and for the manufacturing of products like this one.
Its advanced technology and exacting quality control will do that customers and users enjoy with the
legion of features this system offers. To obtain the maximum profit of these features and a properly wired
installation, we kindly recommend you to expend a few minutes of your time to read this manual.
INDEX
Introduction ...........................................33
Índex.....................................................33
Starting recommendations .......................33
System characteristics ..............................34
System operation ....................................34
Door panel PVS-220 ...................................
Description..........................................35
Location......................................36 to 37
Wiring.................................................37
Final adjustements................................37
Push button label ..................................38
Close the door panel.............................38
Power supply ..............................................
Installation ..........................................39
Characteristics .....................................39
Lock release installation ...........................39
Platea 22 monitor .......................................
Description..........................................40

STARTING RECOMMENDATIONS

O
Do not use excessive force when tightening the power supply connection block screws.
O
Install the equipment without the power connected.
O
Before connecting the system, check the connections between door panel, monitors and the
power supply connection.
O
Only use compatible color and b&w monitor Platea-22.
O
Only use parallel or twisted cable (to sections see page 46).
O
Do not use single wire
O
Do not double the cable to increase the section.
O The entire installation must be at least 40 cm. away from any other installation otherwise there is
a risk that the audio signal be exposed to interference, or that the system does not work correctly.
O
Always use 12 Vd.c. lock releases (cod. 20600149, not included i the kit).
O
Do not switch voltage higher tha 12 Vd.c. / 1A between C and NO door panel terminals.
O
Both monitor and door panel are delivered with a protective film, to avoid scratches during the
installation. These films must removed by the end user only.
O
Do always follow the enclosed information.
.
Function push buttons ...........................41
Call volume control ..............................41
Configuration switches..........................41
Monitor connector description ...............42
Monitor installation...............................43
Changing the front film..........................44
Ring tone selection................................44
Intercom function .................................44
Installation diagram ....................................
One or two door panels.........................45
Connection of an additional monitor.......45
Sections chart ......................................46
Connection a.c. lock release..................46
Connection auxiliary device ...................46
Troubleshooting hints ..............................47
33