Tabla de contenido
Idiomas disponibles
Idiomas disponibles
• Unit will not start.
Problem
For assistance with your product, visit our website at www.portercable.com for a list of
service centers, or call the Porter-Cable Customer Care Center at (888) 848-5175.
CHUCK CAPACITY
R.P.M.
BITS, METAL DRILLING
WOOD, FLAT BORING
BITS, MASONRY DRILLING
Maintenance
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
Replacement Parts
Use only identical replacement parts. For a parts list or to order parts, visit our service website at
www.portercable.com. You can also order parts from your nearest Porter-Cable Factory Service
Center or Porter-Cable Authorized Warranty Service Center. Or, you can call our Customer Care
Center at (888) 848-5175.
Service and Repairs
All quality tools will eventually require servicing and/or replacement of parts. For information about
Porter-Cable, its factory service centers or authorized warranty service centers, visit our website at
www.portercable.com or call our Customer Care Center at (888) 848-5175. All repairs made by our
service centers are fully guaranteed against defective material and workmanship. We cannot
guarantee repairs made or attempted by others.
You can also write to us for information at PORTER-CABLE, 4825 Highway 45 North, Jackson,
Tennessee 38305, (888) 848-5175 - Attention: Product Service. Be sure to include all of the
information shown on the nameplate of your tool (model number, type, serial number, etc.).
Accessories
not been tested with this product, use of such accessories with this tool could be
WARNING:
hazardous. To reduce the risk of injury, only Porter-Cable recommended accessories
should be used with this product.
A complete line of accessories is available from your Porter-Cable Factory Service
Center or a Porter-Cable Authorized Warranty Service Center. Please visit our Web
Site www.portercable.com for a catalog or for the name of your nearest supplier.
Troubleshooting
• Cord not plugged in.
Possible Cause
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
MAXIMUM RECOMMENDED CAPACITIES
1/2 in. (13 mm)
0–1200 / 0–3500
1/2 in. (13 mm) low speed
1-1/2 in. (40 mm)
optimum 3/16 in.–3/8 in. (5–10 mm)
maximum 3/4 in. (20 mm)
Since accessories, other than those offered by Porter-Cable, have
• Plug tool into a working outlet.
Possible Solution
• Replace circuit fuse. (If the
product repeatedly causes the
circuit fuse to blow, discontinue
use immediately and have it
serviced at a Porter Cable
service center or authorized
servicer.)
• Reset circuit breaker. (If the
product repeatedly causes the
circuit breaker to trip,
discontinue use immediately
and have it serviced at a Porter
Cable service center or
authorized servicer.)
• Have cord or switch replaced
at a Porter Cable Service
Center or Authorized Servicer
9
Tabla de contenido
