Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Drill may stall (if overloaded or improperly used) causing a twist.
WARNING:
Always expect the stall. Grip the drill firmly with both hands to control the twisting
action and prevent loss of control which could cause personal injury. If a stall does
occur, release the trigger immediately and determine the reason for the stall before re-
starting.
Assembly
To reduce the risk of injury, before assembly, make sure that the tool
is switched off and unplugged.
WARNING:
Attaching the side handle - (figure C)
If your drill is equipped with a side handle, it
must be installed properly to control the drill
• Turn the grip counterclockwise until you
can slide the side handle (9) onto the front
of the tool as shown.
• Rotate the side handle into the desired
position.
• Insert the depth stop (8) into the mounting
hole as shown.
• Set the drilling depth as described under
"Setting the Drilling Depth".
• Tighten the side handle by turning the grip
clockwise. Make sure that the side handle
is secure and does not slip.
Inserting a drill bit or other accessory (figure D)
gripping the front part of the chuck and turning the tool on. Damage to the
WARNING:
Do not attempt to tighten drill bits (or any other accessory) by
chuck and personal injury may occur when changing accessories.
Always ensure the bit is secure before starting the tool. A loose
bit may eject from tool causing possible
WARNING:
personal injury.
• Open the chuck (6) by turning the collar
counterclockwise (when viewed from the
chuck end).
• Insert the accessory shaft into the chuck
to about 3/4 in. (19 mm) depth, centered in
the jaws.
• Tighten chuck collar by hand by turning
the collar clockwise. Place chuck key (7)
into each of the three holes and securely
tighten in a clockwise direction.
NOTE: Tighten chuck with all three holes
to prevent slippage.
C
D
6
Tabla de contenido
