Additional Information; Important Recycling Advice; Way Manual Lock - Petsafe PPA19-16145 Guia De Inicio Rapido

Ocultar thumbs Ver también para PPA19-16145:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
Basic Operation - Guide
FUNCTION
BUTTON
LED INDICATOR
ACTIVATION
Manual
Press & Release
Red - Solid for 5
Mode
seconds
Automatic
Press & Release
Green - Solid for 5
Mode
seconds
Learn Mode
Press & Hold for
Red – Solid for up to
5 Seconds until
60 seconds
LED is activated
Motion
N/A
Green - Solid for the
Sensor
length of activation
Low Battery
N/A
Red - Flashes every
10 seconds
Batteries
N/A
Green – 3 quick
Replaced
flashes
Factory Reset
Press & Hold 15
Red - 5 quick flashes
Seconds until
LED is activated
Error
N/A
Red – Continuous
quick flashing

4-Way Manual Lock

The 4-Way Manual lock allows you to control your cat's access in and out of
your home in either direction. Until your pet is thoroughly familiar with using the
cat flap, it is a good idea to anly use the 4-Way Manual lock in the In or Out
position only (Fig. H).
6
ACTION
Latch will unlock. Use 4-Way Lock
options for pet access.
Latch will lock and will only
be activated by reading a
"programmed" microchip ID.
Cat flap will exit Learn Mode
once microchip ID is programmed.
Latch will unlock after successful
programming. Repeat for
additional cats.
Motion is detected outside and the
cat flap is looking for a microchip
to read.
Replace batteries soon.
Cat flap will enter Automatic
mode.
Cat flap will enter back into
Automatic Mode and be locked.
All programmed microchip IDs will
be erased from the memory.
Remove batteries, wait 30 seconds
then replace batteries. If Red light
continues, contact the Customer
Care Centre. Latch will attempt to
unlock for cat flap to be used in
Manual Mode.
petsafe.com
In or Out
In only
Fig. H

Additional Information

For extended information on your PetSafe
and wall installation, helpful training tips, and available accessories, please
visit www.petsafe.com to download the full product Installation Guide.

Important recycling advice

Please respect the Waste Electrical and Electrical Equipment regulations in your country. This equipment
must be recycled. If you no longer require this equipment, do not place it in the normal municipal waste
system. Please return it to where it was purchased in order that it can be placed in our recycling system. If
this is not possible, please contact PetSafe
Customer Care Centre for further information.
®
Battery Disposal
Separate collection of spent batteries is required in many regions; check the regulations in your area
before discarding spent batteries. At the end of the product life, please contact one of our Customer Care
Centres to receive instructions on proper disposal of the battery. Please do not dispose of the battery in
household or municipal waste.
Compliance
Radio Systems Corporation declares under its own responsibility, that the following product is in compliance
with the essential requirements under article 3 of the RED (2014/53/EU) and the RoHS Directive
(2011/65/EU). Unauthorised changes or modifications to the equipment that are not approved by Radio
Systems Corporation may violate EU RED regulations, could void the user's authority to operate the
equipment, and will void the warranty.
Hereby, Radio Systems Corporation, declares that this PPA19-16145 product is in compliance with the
essential requirements and other relevant provisions. The Declaration of Conformity can be found at:
http://www.petsafe.net/customercare/eu_docs.php.
Out only
Fully locked
®
Microchip Cat Flap including glass
Tabla de contenido
loading

Tabla de contenido