Petsafe PPA19-16145 Guia De Inicio Rapido página 5

Installation – Glass Doors or Windows
The PetSafe Microchip Cat Flap is also designed for installation into glass
®
and requires a circular hole with a diameter of 212 mm and an Installation
Adaptor (sold separately). Your glazier will need to cut a circular hole of
diameter 212 mm as per the cutting template. Once a glazier has cut the
hole in your glass door or window please follow the instructions below
for installation.
1. Slide one adaptor plate over the tunnel on the interior side of the frame of
the cat flap.
2. From the interior of home, install the cat flap into opening.
3. From exterior of home, slide second adaptor over the tunnel of the
cat flap.
4. Install exterior frame of the cat flap over the attached tunnel.
5. Using appropriate length screws, connect the interior and exterior frames
of the cat flap.
6. Insert blanking plugs (included).
Working with glass is a skilled job and should be carried
out by a professional glazier. It is not possible to cut holes in toughened glass
or double glazed units except at the time of manufacture. Please consult
a glazier.
Installation – Walls
For installation into walls, an Installation Adaptor and Tunnel Extensions must
be purchased separately. Wall fixing screws are not provided with this cat
flap as the type needed will vary greatly depending on your wall construction.
Various fixing types are available from hardware and D.I.Y. stores.
1. Ensure you have the correct number of Tunnel Extensions. The cat flap is
72 mm in depth and each additional Tunnel Extension is 50 mm in depth.
2. For best fit, we recommend using the PetSafe
wall installations.
3. Ensure the installation area is free from utility lines and that proper access
is available for your cat.
Installation Adaptor for
®
Accessories available online
4. Follow the instructions in the Installation – Wooden, PVC, or uPVC Doors
section (Steps 1-5) to cut the hole in your wall. Important: Ensure you
allow proper clearance for the bottom of the Installation Adaptor.
5. Attach one adaptor plate to the interior frame of the cat flap and attach
the second adaptor plate to the exterior frame of the cat flap, using the
hardware provided. Set both frames aside.
6. Stack the Tunnel Extensions together using permanent glue and reinforce
seams with weatherproof tape.
7. Temporarily place the interior frame of cat flap into the wall cut-out. Use a
pencil to mark the four screw holes. Remove interior frame of cat flap and
drill marked holes as is best suited for your wall construction.
8. Attach Tunnel Extensions to the interior frame with weatherproof tape, do
not glue.
9. Install the interior frame of cat flap and attach to the wall using
appropriate hardware for your wall construction.
10. Temporarily place exterior frame of cat flap into the wall cut-out. Use a
pencil to mark the four screw holes. Remove exterior frame of cat flap
and drill marked holes as is best suited for your wall construction.
11. Install the exterior frame of cat flap and attach to the wall using
appropriate hardware your wall construction.
12. Install blanking plugs (included).
5