During Regeneration; Manual Regeneration; Manual Delayed Regeneration; Immediate Regeneration - Pentair RIVERSOFT Guía De Usuario

User Guide Riversoft

7.1.2. During regeneration

• The controller will display a cascading symbol "--" until regeneration is complete.
• If a button is pressed the current time and cycle will be displayed alternately.
7.2.

Manual regeneration

MANDATORY
The controller must be in service in order to enable this procedure.
NOTE

The unit returns to normal operation if no buttons are pressed within 30 seconds.

7.2.1. Manual delayed regeneration

A Press once for delayed regeneration.
→ The regeneration will start on the scheduled time. See chapter 5.1. Display, page 15.
→ The regeneration dot will blink when delayed regeneration is on.
NOTE

To cancel: press

7.2.2. Immediate regeneration

A Press and hold for 3 seconds to initiate immediate manual regeneration.
→ The controller will display a cascading symbol "--" as it cycles to backwash.
→ The controller will proceed through a complete regeneration.

7.2.3. To advance regeneration cycles

A Simultaneously press
→ When the camshaft reaches the next cycle, "C#" will be displayed.
→ Repeat and

7.2.4. To cancel a regeneration

A Press and hold and
→ The controller will skip the remaining regeneration cycles and return to the service position. It may take 1 to 2 minutes.
→ The time of day will be displayed when the controller reaches the service position.
18 / 132

again. The regeneration dot disappears.
and to advance to the next cycle.
to advance through each cycle.
for 3 seconds during any regeneration cycle to cancel it.
Ref. MKT-UG-045 / A - 13.03.2020