V2 DEV-R1 Manual Del Usuario página 9

ARTEMIS SERIES TRANSMITTERS STORAGE
PROCEDURE (FIG.5)
m
CAUTION: The data storage of the first transmitter
determines the direction of motion of the motor.
m
CAUTION: If the awning has a casing carry out the data
storage of the first remote control by following the procedure
"TRANSMITTER DATA STORAGE"
To store your remote controls on a virgin control unit which
drives a shutter or an awning (WITHOUT casing) proceed as
follows:
1. Supply power only to the control unit to be programmed
2. Activate the programming by following one of these
procedures
Artemis with 1 channel:
• Press and hold down the UP+DOWN keys until the motor
starts to move in one direction
Artemis with 2 channels:
• Press the UP+DOWN keys of one of the two channels until
the motor starts to move in one direction
Artemis with 6 channels:
• Select the channel to be programmed with the C key
• Press the UP+DOWN keys until the motor starts to move in
one direction
3. Release the keys: the motor stops
4. Press the UP or DOWN keys according to the direction in which
the roll-up shutter was moving before it stopped:
- if the roll-up shutter was being raised press the UP key;
direction obtained: the UP key raises the roll-up shutter, the
DOWN key lowers the roll-up shutter
- if the roll-up shutter was being lowered press the DOWN
key; direction obtained: the DOWN key lowers the roll-up
shutter, the UP key raises the roll-up shutter.
5. Programming is complete
To add additional remote controls, proceed as follows:
6. Press and hold down the UP+DOWN keys of a remote control
which has already been programmed until the motor starts to
move in one direction
7. Release the keys: the motor stops
8. Press the UP or DOWN key of the new remote control
NOTE: to clear the transmitters, follow the procedure
described in paragraph MEMORY CLEARING BY MEANS OF
BUTTON SW1
DEV-T1 SERIES TRANSMITTERS STORAGE
PROCEDURE (FIG.6)
P1 = UP
P2 = STOP
P3 = DOWN
P4 = PROG
To record remote controls for a new control unit that drives
a shutter or a sunshade proceed as follows:
CAUTION: the first transmitter recorded determines the direction
of the motor's movement.
1. Press the button SW1 of the module DEV-R1: the led L1 lights
up
2. Press and hold down P4 until the motor starts to move in a
direction: the led L1 turns off
3. Release the button: the motor will stop
4. Press UP or DOWN following the direction the roll-up shutter
moved prior to stopping:
- if the roll-up shutter was rising, press UP; direction acquired:
the UP button raises the roll-up shutter, the DOWN button
lowers the roll-up shutter
- if the roll-up shutter was lowering, press DOWN; direction
acquired: the DOWN button lowers the roll-up shutter, the
UP button raises the roll-up shutter
5. End of programming
To add other remote controls, proceed as follows:
6. Press and hold down the P4 button of DEV-T1 that is already
recorded until the motor starts to move in a direction
7. Release the button: the motor will stop
8. Press the UP or DOWN button on the new remote control
NOTE: to clear the transmitters, follow the procedure
described in paragraph MEMORY CLEARING BY MEANS OF
BUTTON SW1
- 9 -