Tire Inspection; Checking The Oil Level - E-Z-GO TXT GASOLINA Manual Del Propietário

Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
FUEL SYSTEM
THROTTLE/GOVERNOR LINKAGE
HARDWARE AND FASTENERS
SEMI-ANNUAL - 125 HOURS
BATTERY
DIRECTION SELECTOR
KING PINS
STEERING ASSEMBLY
RACK END BALL JOINT
REAR AXLE
AIR FILTER ELEMENT
OIL FILTER
ENGINE OIL
DRIVE BELT
ANNUAL - 250-300 HOURS
FRONT WHEEL BEARINGS
REAR AXLE
SERVICE BRAKES
FUEL FILTER
SPARK PLUGS
MUFFLER/EXHAUST
VALVES
500 HOURS
TIMING BELT
CARBURETOR
CYLINDER HEAD AND PISTONS

TIRE INSPECTION

Tire condition should be inspected per the Periodic Ser-
vice Schedule (Ref. Fig. 16 on page 14). Inflation pres-
sures should be checked when the tires are cool. Be sure
to install the valve dust cap after checking or inflating.

CHECKING THE OIL LEVEL

Do not overfill engine. Too much oil may cause engine to
smoke or spark plug fouling.
OPERATION AND SERVICE INFORMATION
Check for leaks at tank, cap, system lines, filters, pump, carburetor
Check system lines for cracks/deterioration
Check operation and governed speed
Check for loose or missing hardware and components
Tighten or replace missing hardware
(includes items listed in previous tables & the following)
Clean battery & terminals
Check for wear and smooth movement (lubricate shaft with light oil if required)
Check for excessive play and tightness of retaining nuts
Check bellows and pinion seal for damage or grease leakage
Lubricate, use wheel bearing grease
Check for unusual noise and loose or missing mounting hardware
Check filter element, clean/replace as required
Clean in solvent (at oil change), replace 'O' rings if required
Replace with SAE 10W-30 or 10W-40 that meets or exceeds SF, SG, CC oil,
DO NOT OVERFILL
Check for cracks, fraying and excessive wear
(includes items listed in previous tables & the following)
Check and adjust as required, see Technician's Repair and Service Manual
Check lubricant, add lubricant (Ref Fig. 37 on page 23) as required
Clean and adjust, see Technician's Repair and Service Manual
Check brake shoe linings, see Technician's Repair and Service Manual
Check level, add if required (DOT 3) and check for leakage
Replace
Replace, gap new plugs (Ref Fig. 37 on page 23)
Check mounting hardware; check for leaks at head and muffler gaskets
Check cold (intake/exhaust) per Technician's Repair and Service Manual
(includes items listed in previous tables & the following)
Check tension and for signs of wear/damage, replace if worn or damaged
Clean
Remove carbon from cylinder head and pistons
Check valve seats for carbon buildup and clean as required
Fig. 16 Periodic Service Schedule
Owner's Manual and Service Guide
.
When adding oil between oil changes, do not mix brands and
viscosity grades of oil. Both the oil dipstick and fill cap must be
in place before operating the engine. Failure to install the dip-
stick and fill cap will result in oil becoming contaminated and/or
oil being discharged into the engine compartment.
Page 15