Parts And Functions - Haier HSU18VHJ Manual Del Usuario

Parts and Functions

Indoor Unit
Inlet grille
Inlet
Outlet
Anion generator
(inside)
Horizontal flap
(adjust up and down air flow
Don't adjust it manually)
Actual inlet grille may vary from the one shown in the
manual according to the product purchased
Display board for 12:
Singal receiver hole
COOL display
HEAT display
TEMP display
HEALTH display
Display board for 18:
Remote signal receiver
HEALTH display
TIMER OFF display
TIMER ON display
SLEEP display
TEMP display
Outdoor Unit
OUTLET
CONNECTING PIPING AND ELECTRICAL WIRING
DRAIN HOSE
INLET
2
Air Purifying Filter
Emergency
Switch
Vertical blade
(adjust left and right air flow)
Display board
F
(
If the unit which you purchased
has healthy function,follow it.
If not,please ignore.)
Dry display
TIMER OFF display
TIMER ON display
SLEEP display
F
AUTO display
COOL display
Dry display
HEAT display
4
Remote controller
B A
19
C
F
.5
28
30
CODE
31
1. RESET button
When the remote
controller appears
abnormal, use a sharp
pointed article to press
this button to reset the
remote controller normal.
2.LIGHT button
Control the lightening and
the indoor
extinguishing of
LED display board.
3. TIMER button
4. CLOCK button
5. SLEEP button
6. MODE button
7. HOUR button
NOTE:
Cooling only units do not have the functions and displays related
with heating.
The following functions and related displays are not available:
Loading of the battery
1
2
2 R-03 batteries, resetting key
(cylinder);
3
Be sure that the loading
4 is in line with the " + "/"-";
Load the battery,then put on the cover again.
Note:
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.
When electronic-started type fluorescent lamp or change-over
wireless telephone is installed in the
type fluorescent lamp or
room, the recei ver is apt to be disturbed in receiving the signals,
so the distance to the indoor unit should be shorter.
Full display or unclear display during operation indicates the
batte ries have been used up. Please change batteries.
If the remote controller can't run normally during operation, please
reload several minutes later.
remove the batteries and
Hint:
Remove the batteries in case won't be in use for a long period. If
there is any display after taking-out, just press reset key.
8. HEALTH button
9. ON/OFF button
10. TIMER ON display
11. FAN SPEED display
LOW HI
MED
12. LOCK display
13. SWING UP/DOWN display
14. SLEEP display
15. HEALTH display
16. Operation mode display
Operation mode AUTO COOL DRY
Remote controller
17.Singal sending display
18. POWER/SOFT display
19. Left/right air flow display
20. TEMP display
21. TIMER OFF display
22. TIMER display
23. TEMP button
24. FAN button
25. HEALTH AIRFLOW button
26. SWING UP/DOWN button
27. SWING LEFT/RIGHT button
28. SET button
29. POWER/SOFT button
30 . LOCK button
If pressed, the other buttons
will be disabled. Press it once
again,lock will be cancelled.
31 . CODE button
Use to select CODE A or B which
will be displayed on LCD. Please
select A without special explanation.
Remove the battery cover;
Load the batteries as illustrated.
AUTO
HEAT FAN