Parts And Functions - Haier AS09FBAHRA Operación Manual

Parts and Functions

Indoor Unit
Display board
Inlet
Inlet grille
Outlet
Air Purifying Filter
Vertical blade
(inside)
(adjust left and
right air fl
Display board B
1
Signal receiver hole
2 Ambient temp.display
When receiving the remote
control signal, display the set
temperature.
Actual inlet grille may vary from the one shown in the
manual according to the product purchased
Outdoor Unit
OUTLET
CONNECTING PIPING AND ELECTRICAL WIRING
DRAIN HOSE
INLET
Please be subject to the actual produce purchased the
above picture is just from your reference
1
(inside)
ow)
Horizontal flap
(adjust up and down air flow
Don't adjust it manually)
1
2
Operation mode indicator
3
(lights up when the compressor is on.)
4
WIFI
4
Remote controller
1
2
3
4
5
9
10
ON/OFF
11
Button
12
SWING
13
14
15
4 16
17
3
1. Mode display
Operation mode
AUTO COOL
Remote controller
2. Signal sending display
3. SWING display
4. FAN SPEED display
LOW MED HI
5. LOCK display
6. TIMER OFF display
TIMER ON display
7. TEMP display
Healthy function is not available for some units.
Loading of the battery
4
Load the battery,then put on the cover again.
Note:
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.
When electronic-started type fluorescent lamp or change- over
type fluorescent lamp or
room, the recei
so the distance to the indoor unit should be shorter.
Full display or unclear display during operation indicates the
batte ries have been used up. Please change batteries.
If the remote controller can't run normally during operation, please
remove the batteries and
Hint:
Remove the batteries in case won't be in use for a long period. If
there is any display after taking-out, just press reset key.
8. Additional functions display
6
Operation mode QUIET
7
Remote controller
9. QUIET button
10. HEAT button
8
11. COOL button
12. SWING LEFT/RIGHT button
18
13. FAN SPEED button
14. TIMER button
19
15. HEALTH button
20
16. LOCK button
Used to lock buttons and LCD display
SWING 17. LIGHT button
21
Control the lightening and extinguishing
22
of the indoor LED display board.
18. POWER ON/OFF button
23
19. DRY button
24
20. TEMP button
21. SWING UP/DOWN button
25
22. HOUR button
23. EXTRA FUNCTION button
Function: Sleeping---- Healthy
airflow position1--- Healthy airflow
DRY FAN HEAT
position2---
--- A-B yard
24.CANCEL/CONFIRM button
Function: Setting and cancel to the
Display
timer and other additional functions.
circulated
AUTO
25. RESET button
When the remote controller appears
abnormal, use a sharp pointed
article to press this button to reset
the remote.
1
Remove the battery cover;
2
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
3
Be sure that the loading
is in line with th
wireless telephone is installed in the
ver is apt to be disturbed in receiving the signals,
reload several minutes later.
Supplemented
electrical
SLEEP HEALTH TURBO
heating
standard position --- Power
--- AUTO --- 10 Heating
o
C
e" + "/"-";