Black and Decker VCBD8080 Manual Del Usuario página 12

DUAL CYCLONIC FILTER
To remove the dual cyclonic filter
22. Turn the dust collector to the unlock
23. Grasp cyclonic filter screen, turn it counterclockwise (OPEN) and pull out.
24. Clean cyclonic filter and filter screen using a small brush. If needed, wash with mild soap and rinse with
cold tap water. Do not use any abrasive cleaners.
25. Shake excess water from cyclonic filter and let it dry completely before inserting back into the unit.
To replace dual cyclonic filter
26. Grasp the cyclonic filter screen with the tabs facing down and turn the filter screen to the (close) position.
27. Insert the cyclonic filter screen into the dust collector and turn the dust collector to the lock position
until it snaps into place.
28. Insert dust collector back in canister compartment.
Tip: Pull on the handle to verify that it is secured in place.
HEPA GRADE INTAKE FILTER
The HEPA grade intake filter is located at the top of the dust collector inside the lid.
29. Open the lid by pulling the catch at the end of the handle.
30. Remove the filter by pressing the lock tab.
31. Clean the sponge and the filter with soap and water, and allow to dry before reinstalling.
32. Insert filter back into the dust collector or replace with a new filter and close the lid.
33. Insert dust collector back in canister compartment.
HEPA EXHAUST FILTER
The HEPA exhaust filter is located at the back of the canister.
34. Push up the left the locking clip on the exhaust filter cover and pull out.
35. Grasp the HEPA filter and pull out.
36. Clean the HEPA filter with soap and water, and allow to dry thoroughly before reinstalling.
37. Insert the HEPA filter back into the canister or replace with a new filter and snap cover back in place.
position and take out the cyclonic filter.
12