Drum/Caddy Assembly (Ws1600Caex0) - Workshop WS1200VAEX0 Manual Del Propietário

DRum/cADDY AssemblY
Do not assemble until you have all the
parts.
With the power head and lid assembly
removed from the drum, and the drum
upside down on the floor:
1. Insert caddy left and caddy right into
the bottom of drum as shown. Light
taps with a mallet or hammer may be
needed to fully seat both caddies.
2. Install (4) #10 x 1-3/4" screws into
matching holes on both right and left
side of caddy, securing them to the
bottom of the drum. Tighten screws
until just snug. Do not over tighten as
this may tend to deform the caddies.
3. Installing Cap Nut:
a. Place cap nut on end of axle.
b. Tap gently with hammer until fully
seated.
c. Place wheel on the axle with
smooth portion of wheel facing
outward.
(Ws1600cAeX0)
Drain
#10 x 1-3/4"
Screw (4)
Caddy Left
Open
End
Cap
Nut
7
Caddy
Right
Left Caddy
Assembly
Drain
Right
Caddy
Assembly
Drain
Axle
w/Wheel
NOTE: Smooth side of the
wheel to the outside.
Caddy
Left
Caddy
Right