Cleaning A Dry Filter; Cleaning A Wet Filter; Cleaning And Disinfecting The Wet/Dry Vac - Workshop WS1200VAEX0 Manual Del Propietário

NoTe: Failure to properly seat the
bottom gasket could result in debris
bypassing the Filter.
WARNING: Do not operate without
filter cage and float, as they prevent
liquid from entering the impeller and
damaging the motor.
(Ws1600cAeX0)
Integrated Filter
Plate with Center
Hole
Filter
Tabs (2)
Filter
Cage
Lid
(Ws1200vAeX0)
Integrated Filter
Plate with Center
Hole
Filter
Tabs (2)
Filter
Cage
Lid
mAINTeNANce (continued)
PUSH
DOWN
PULL
UP
Rubber
Gasket at
Bottom of
Filter
(cutaway
view)
Qwik
Lock™
Stud
PUSH
DOWN
PULL
UP
Rubber
Gasket at
Bottom of
Filter
(cutaway
view)
Qwik
Lock™
Stud

cleaning A Dry filter

NoTe: For best cleaning results due to
accumulated dust, clean the Filter in an
open area. Cleaning SHOULD be done
outdoors and not in the living quarters.
1. Light cleaning of some dry debris from
the Filter can be accomplished without
removing the Filter from the Vac.
Simply slap your hand on top of the
handle while the Vac is turned off.
2. Remove Filter from Vac. Gently tap
the Filter against the inside wall of
your dust drum and the debris will
loosen and fall.
3. For thorough cleaning of a dry Filter
with fine dust (no debris) you may run
water through it as described under
"Cleaning A Wet Filter" Section.

cleaning A Wet filter

After Filter is removed, run water through
the Filter from a hose or spigot. Take care
that water pressure from the hose is not
strong enough to damage Filter. Allow
Filter to dry out before storing.
cleaning and Disinfecting the
Wet/Dry vac
To keep your Wet/Dry Vac looking its
best, clean the outside with a cloth
dampened with warm water and mild
soap.
To clean the drum:
1. Dump debris out.
2. Wash drum thoroughly with warm
water and mild soap.
3. Wipe out with dry cloth.
Before prolonged storage or as needed
(i.e.; waste water pick up) the drum
should be disinfected.
17