Tabla de contenido
Idiomas disponibles
Idiomas disponibles
9
10
7
Programming and confi guration
There are two programming levels:
1.
Confi guration (see chap. 9), to program main parameters (input type,
measure unit, P.I.D. parameters ext.);
2.
Cycle programming, to defi ne time-setpoint couples which creates
cycle steps.
7.1 Entering or modifying a fi ring curve
The controller must be in STOP-mode and follows the points below.
Press
1
2
3
GB
12
START / STOP key
• ESCAPE –key if programming parameters or cycles.
Scrolls through the cycles to select or start one
• Keep pressing it for about 5 sec. to enter confi guration
mode.
Display
Value on display changes
st
Displays the 1
selected program. The number
of segments (1-9, A,B,C,D,E,F,) is
displayed on the 2
Press
to scroll through and en-
ter time and temperature values
(and auxiliary relay if available)
for each segment
Increase or decrease
the displayed value.
Press
to scroll through the
parameters of selected cycle.
segment of the
nd
display.
Do
Main display shows
Press the key to scroll through
the available programs and
fi nally the function "simple
controller
chosen program is displayed
To program the delayed start
of fi ring cycle, enter the time
value (0:00-09:59) for step 0.
Otherwise skip to step no. 1
Enter the setpoint value (required
temperature). Led
Enter
duration
(hours:minutes). To set the maxi-
mum rise speed, press
is displayed. Led
is On.
.
, until the
is On.
of
segment
until
Tabla de contenido
