Auto-Tune; Confi Guration; To Change Values; Setting Of Confi Guration Parameters - Pixsys ATR 900 Manual Instalador

Ocultar thumbs Ver también para ATR 900:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

8.9 Auto-tune

The Auto-tuning
is running, if it has been previously enabled by parameter P-12.
The process value (temperature measured by sensor) must be at least 35% lower
than setpoint value to avoid overfl ow.
Press
1
2
9

Confi guration

9.1 To change values

To increase or decrease the displayed value, just press
Press
to skip to next parameter.

9.2 Setting of confi guration parameters

To enter or change the confi guration parameters (see par. 10), the controller must
be in STOP-mode.
Press
1
Press
for 5 s.
1
Access to this function may be desabled (see parameter
GB
16
1
process may be launched when the function "simple controller"
Display
Value on display changes
Display
alternates between

and temperature of
kiln. Led STARTS to fl ash.
The controller starts the self-
tuning process.
Display
Display visualizes
the 1st number on the left
fl ashes.
Display shows
Wait until display shows the
kiln temperature again, after
the process has been comple-
ted. To interrupt the process,
press

and
 
Do

.
or
.
Do
).
fl ashing.
Tabla de contenido
loading

Este manual también es adecuado para:

Atr 901

Tabla de contenido