Rola Haul-Your-Might T3 Manual De Instrucciones página 5

Please read all instructions carefully before assembly, installation and/or use of this product.
7
•
Secure crossbars to vertical supports using the M10 flat washers, lock washers, and hex nuts onto T-Bolts in crossbars.
•
Securely tighten all M10 fasteners to 38 Lb.-Ft. (52 N*M)
8
9
Cequent Performance Products, Inc.
Plymouth, MI 48170
Technical Service: (888) 521-0510
Product Name:
Product Code:
M10 Flat Washer
M10 Lock washer
M10 Hex nut
(8) Places
•
Firmly and evenly hand tighten all (8) clamping knobs.
•
Note: The Locking Clamp Knob is locked when it is free to spin.
•
Raise corner brace into position and attach the top of brace to M8 T-bolt
in crossbar using (1) M8 hex nut and lock washer as shown.
Note: Adjust under covers so corner brace sits flat against crossbar.
•
Next, install the M8 Button head screw and lock washer into the rivet nut
in vertical support tube.
•
Securely tighten all M8 fasteners to 25 Lb.-Ft. (34 N*M)
Note: M5 hex wrench provided for button head screw.
•
Repeat steps for all four corner braces.
M8 Lock Washer
M8 Hex Nut
M8 Lock Washer
M8 Button Head Screw
WARNING
Always secure front and rear of long
loads to ends of vehicle for safe
transport. Failure to do so can result
in property damage, personal injury, or
death.
Page 5 of 7
Haul-Your-Might™ T3
59799
Buffer strip
Unlocked
REMOVE YOUR RACK AND
ACCESSORIES WHEN NOT
IN USE AND BEFORE
ENTERING AUTOMATIC
Remove end cap and
buffer strip to utilize
Accessory T-Slot in
crossbar
Locked
under
covers
CAR WASHES
59799N 2-15
Printed in China Printed in China