DWT ESP01-250 Manual Original página 21

Symbol
power tool designation
This power tool is designed for spraying and applying
liquid materials on a treated surface� It allows the user
to apply paints, varnishes, primers, preservatives, pro-
tective and disinfectant materials, as well as to spray
water for wetting surfaces�
Power tool
components
1 Nozzle
2 Air cap
3 Coupling nut
4 Button
5 Reservoir
6 Spray volume regulator
7 Air hose
8 Cover
9 On / off switch
10 Spray gun holder
11 Base unit
12 Measuring funnel *
13 Cleaning rod *
14 Carrying belt *
15 Purge nozzle *
Meaning
Minimum amount of sprayed
material�
Maximum amount of sprayed
material�
Runout time via measuring
cup�
Double insulation / protec-
tion class�
Attention� Important�
A sign certifying that the
product complies with es-
sential requirements of the
EU directives and harmo-
nized EU standards�
Useful information�
Do not dispose of the power
tool in a domestic waste
container�
DWT
16 Ventilation slots
17 Flexible extension hose *
18 Tube
19 Nut
20 Lock nut
21 Discharge opening
22 Tip for connection to the base unit
23 Tip for connection of accessories
24 Filter
25 Suction hole
26 Drain hole
27 Air filter *
* Optional extra
Not all of the accessories illustrated or described
are included as standard delivery.
Installation and regulation
of power tool elements
Before carrying out any works on the power tool it
must be disconnected from the mains.
Do not draw up the fastening elements
too tight to avoid damaging the thread.
Mounting / dismounting / setting-up of
some elements is the same for all power
tool models, in this case specific models
are not indicated in the illustration.
Reservoir connection / disconnection (see fig. 1-2)
Connect / disconnect reservoir 5 as shown on fig-
ures 1-2�
[ESP05-200 T]
Prior to connecting reservoir 5, turn tube 18 (see
fig. 2.2) into the position allowing maximum use up of
the material� It depends on where the spray gun will be
tilted during operation (see fig. 2.3-2.4).
• Loosen the lock nut 20 and unscrew the nut 19�
• Turn the tube 18 to the required position�
• Screw the nut 19 and secure it by tightening the lock
nut 20�
Flexible extension hose connection / disconnec-
tion (see fig. 3)
[ESP01-250]
• Flexible extension hose 17 allows spraying material
onto horizontal surfaces as well as in hard-to-reach
places (for example, when painting heating radiators)�
• Unscrew nozzle 1 (see fig. 3).
• Screw flexible extension hose 17 on, then bend it
into the required position�
• In order to disconnect, perform these steps in re-
verse order�
Air hose connection / disconnection (see fig. 4)
[ESP05-200 T]
• Connect the air hose 7 to the base unit 11� Insert the
tip 22 into the opening 21 after aligning the protrusions
English
21