Accessories, Consumables - Hilti TE 700-AVR Manual De Instrucciones

Recommended minimum conductor cross section and max. cable lengths
Conductor cross section
Mains voltage 120 V
Do not use extension cords with 16 AWG conductor cross section.
en
2.12 Using extension cords outdoors
When working outdoors, use only extension cords that are approved and correspondingly marked for this application.
2.13 Using a generator or transformer
This power tool may be powered by a generator or transformer when the following conditions are fulfilled: The unit
must provide a power output in watts of at least twice the value printed on the type identification plate on the power
tool. The operating voltage must remain within +5% and -15% of the rated voltage at all times, frequency must be in
the 50 – 60 Hz range and never above 65 Hz, and the unit must be equipped with automatic voltage regulation and
starting boost.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching other
power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in damage to the
power tool.

3 Accessories, consumables

Designation
TPS Theft Protection System with
Company Card, Company Remote
and TPS‑K key
Dust removal module
Use the Hilti chisels or other tools listed below. With these you will achieve higher performance and longer
lifetime as the power tool and chisels have been optimized as a system.
Pointed chisels
Flat chisels
Wide-flat chisels
Flexible chisel
4
14 AWG
50 ft
Short designation
TE DRS‑B
TE‑Y chuck /
tool descrip- Width (mm)
tion
TE‑YP SM 28
TE‑YP SM 36
TE‑YP SM 50
TE‑YP SM 70
TE‑YP FM 28
TE‑YP FM 36
TE‑YP FM 50
TE‑YP FM 70
TE‑YP 50
SPM 5/28
TE‑YP 50
SPM 5/36
TE‑YP 80
SPM 8/28
TE‑YP 120
SPM 12/36
TE‑SP 120
SPM 12/50
TE‑Y 150
BSPM 800
12 AWG
125 ft
Item number, description
206999, optional
Width in
Length (mm)
inches
280
360
500
700
280
360
500
700
280 2
360 2
280 3
360 4³⁄₄
500 4³⁄₄
650 6
Length in
inches
11
14
19
27
11
14
19
27
11
14
11
14
19
25¹⁄₂