Kohler K-1188BR Guia De Instalacion página 53

Make the Electrical Connections (cont.)
NOTE: The product model number is printed on a label on the pump side of the whirlpool bath. This label
also identifies the electrical rating of the product. All whirlpools come equipped with a wiring junction box
and are designed to operate between 220 V and 240 V at either 50 Hz or 60 Hz.
WARNING: Risk of electrical shock. Make sure the power has been disconnected before
performing the following procedures. Refer to the "Important Information" section.
WARNING: Risk of electrical shock. To reduce the risk of electrical shock, connect the pump to
a properly grounded Residual Current Device (RCD). This will provide additional protection
against line-to-ground shock hazard. A 220-240 V, 20 A, 50/60 Hz dedicated circuit is required.
The whirlpool bath control and heater system have been pre-wired at the factory. A qualified
electrician should make a routine service connection to the junction box.
Connect service to the junction box. The junction box contains blue, brown, and green with a yellow
stripe colored wires.
Follow local electrical codes. Bond in accordance with national and local codes.
A wiring harness has been pre-wired at the factory, allowing communication between the keypad,
all features, and the control. No additional wiring is required, but ensure that all wires are securely
fastened.
NOTE: Your wiring harness includes an antenna for the optional remote control. Do not alter or
damage this antenna during installation.
Kohler Co.
English-11
1019731-BR2-A