Ford F-Serie Manual De Instrucciones página 108

F-SERIES SUPER DUTY BODY INSTALLATION FOR CREW CAB OUTER ROCKER PANEL
Part Number
HC3B-2610128-A*
SKHC3B-2610128-AB
Part Number
HC3B-2610129-A*
SKHC3B-2610128-AB
Part Number
W702512-S900C
W708777-S900C
W710246-S900
Motorcraft TA-1, 3M 8115 or
Fusor 108B
SERVICE GUIDELINES:
• Aluminum repairs should be performed in an area protected from steel working areas, and tools used in
aluminum repair should be quarantined from steel repair tools.
NOTE: If SPRs are called out in the materials table and procedure as a possible repair option, the
replacement SPRs must be installed adjacent to the original SPR Locations.
• Blind rivets may be installed in original SPR holes, after they are reamed out to 6.5mm. Be sure to grind all
surfaces of the flange smooth prior to blind rivet installation in original SPR locations.
• Flow Drill Screws (FDS) are to be replaced by blind rivets only. The original location of the FDS is used, but
reamed out to 6.5mm.
• Rivets may be removed by drilling, grinding, or SPR gun set up as a rivet removal tool.
• Using heat (not exceeding 425°F) to loosen a rivet bonded panel should only be done when all panels in the
joint will be replaced or separated and new adhesive applied.
• Flange preparation for adhesive is to grind to clean metal with 80-120 grit, clean, and then apply the adhesive,
spreading it out with an acid brush, covering any exposed aluminum.
• Clecos are an excellent way to hold the panels into position when fitting and drilling rivet holes.
REINFORCEMENT - SERVICE KIT INSTRUCTIONS
Outer Rocker Panel Reinforcement (RH) - Crew Cab
Instruction Sheet
Outer Rocker Panel Reinforcement (LH) - Crew Cab
Instruction Sheet
NOT INCLUDED IN KIT (PROCURE LOCALLY)
Blind Rivet
Blind Rivet
Self-Piercing Rivet (SPR) Code BN
Metal Panel Bonding Adhesive
CPR © 2016 FORD MOTOR COMPANY
DEARBORN, MICHIGAN 48121
4-16
KIT
Description
KIT
Description
Description
SKHC3B-2610128-AB
F-SERIES SUPER DUTY BODY INSTALLATION
FOR CREW CAB OUTER
ROCKER PANEL REINFORCEMENT -
SERVICE KIT INSTRUCTIONS
Quantity
1
1
Quantity
1
1
Quantity
13
10
5
1
SHEET 1 OF 2