Setup Instructions; Checking The Contents - Uline H-800 Manual Del Usuario

UnPAckInG
When you open the top flaps on the box for the tape
dispenser, there will be instructions for removing the
tape dispenser from its packaging. Save the box and
packing materials in case you need to ship the unit at
some future time.

cHEckInG THE cOnTEnTS

Packaged inside the tape dispenser, under the top
cover are the following items: (See Figure 1)
Figure 1
Operating
Guide
Power
Cord
Upper
Tape
Plate
• Brush Assembly (three beveled brushes
assembled together)
• Water Tank (a black plastic piece with a metal
bracket attached to it)
• Bottle (a white plastic bottle with a screw cap)
• Upper Tape Plate
• Power cord
• Operating Guide
• Warranty card (inside the Operating Guide)
• 2 Tape Roll Guides (See Figure 2)
PAGE 2 OF 24

SETUP INSTRUCTIONS

PREPARING THE UNIT FOR OPERATION
ADjUSTInG THE ROLL GUIDES
Roll guides fit into slots in the front and bottom panels
of the tape basket. They hold the tape roll vertical to
allow the tape to unwind. You must adjust these guides
for the size of the tape being used.
PROcEDURE
1. Remove a guide from its current position by
grasping the guide, lifting it up and pulling the
bottom of it to the rear of the unit. (See Figure 2)
Water Bottle
Brushes
Water Tank
2. Reinsert each guide pressing tabs first into the
bottom slot and then rotating into the front slot.
(See Figure 3)
NOTE: This machine can dispense tapes from
1½" to 3" wide.
Roll Guides
Figure 2
Insert all four tabs the same number of
slots from the outside edge.
Figure 3
1013 IH-800