General Information; Setup Instructions - Uline Better Pack 333 Plus Guia De Inicio Rapido

BEFORE USING THE MACHINE
After removing the machine from the carton, check the
following items before storing the shipping cartons:
• Brush Tank and two Moistening Brushes: These are
packed inside the rear of the machine.
• Plastic Water Bottle: This is packed on the side of the
dispenser.
SETUP
1. If the upper tape plate has been dislodged in
shipping, replace as follows:
With the slot towards the front of the machine, slide feed
wheel shaft under from rear until the cut-out portions
are over the Retaining Buttons. Allow the plate to slide in
place so that the front end of the plate is under the rod,
and the rear portion is under the buttons. (See Figure 2)
Figure 2
Retaining
Buttons
Feed
Wheel
Shaft
Rod
2. Wash out the moistening brushes in soap or mild
detergent and place both brushes into the tank so
the angle on the brushes slopes toward the rear of
the tank. (See Figure 3)
Figure 3
3. Insert the tank into the opening on the front of the
machine, making sure the tank is behind the upward
lip on the tank shelf.
PAGE 2 OF 8

GENERAL INFORMATION

• Upper Tape Plate: This is

SETUP INSTRUCTIONS

4. Fill the bottle with water and place in the bottle
5. Adjust the roll guides for proper width of tape.
6. To load tape, take the roll of tape and peel off about
18 inches. Place the roll of tape in the basket so that
held in position by packing
material but may have
become dislodged in
shipping. Remove tape, etc
before using the machine.
(See Figure 1)
holder so that the spout of the bottle is in the tank.
the strip of tape unwinds off the rear of the roll as
the leading end is brought towards the front of the
machine with the gummed side down. Thread the
tape over the black roller at the upper rear and slide
leading edge forward under the upper tape plate
and feed wheel. Close front and rear covers.
(See Figures 4a and 4b)
Figure 4a
Figure 4b
Black Roller
Tape
Figure 1
0913 IH-35