Idiomas disponibles

Idiomas disponibles

H-801
PAPER TAPE DISPENSER – 3"
FILLING TANK
1.
Remove screws and bridge from dispenser.
(See Figure 1)
Figure 1
2. Remove and thoroughly wash brush in warm, soapy
water before initial use. (See Figure 2)
Figure 2
Brush
Tank
3. Fill tank to 1/2" from top.
NOTE: To remove tank, first remove bridge, then
lift tank off of the dispenser
4. Replace brush and close lid on tank.
5. Reattach bridge to dispenser with previously
removed screws.
PAGE 1 OF 6
INSTRUCTIONS
Bridge
1-800-295-5510
uline.com
LOADING TAPE
1.
Unroll 15 inches of tape.
2. Adjust tape divider to width of tape. Place tape in
cradle. (See Figures 3-4)
NOTE: Unwound portion of tape should be on
bottom of roll off the back and with adhesive
side facing up.
Figure 3
Tape Divider
3. Insert tape end in back of two rollers. Push tape
through the underside of the dispenser until the end
comes out in front of the tape cradle. (See Figure 5)
Figure 5
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Figure 4
Adhesive Side
of Tape
0522 IH-801
Tabla de contenido
loading

Resumen de contenidos para Uline H-801

  • Página 3: Instrucciones

    H-801 800-295-5510 uline.mx DESPACHADOR PARA CINTA DE PAPEL – 3" INSTRUCCIONES LLENADO DEL TANQUE CARGA DE LA CINTA ADHESIVA Retire los tornillos y el puente del despachador. Desenrolle 38 cm (15 pulgadas) de cinta. (Vea Diagrama 1) 2. Ajuste el separador de cinta al ancho de la cinta.
  • Página 4: Continuación De Instrucciones

    • Lave el cepillo con jabón y enjuáguelo una vez a la semana para eliminar la acumulación de adhesivo. 800-295-5510 uline.mx PAGE 4 OF 6 0522 IH-801...

Tabla de contenido