Beurer MP 60 Instrucciones Para El Uso página 9

When filing, always work from the outside of the nail towards the tip!
Always check results regularly during treatment. As soon as the application becomes un-
pleasant, stop the treatment.
4. Cleaning
Before cleaning the power unit, always unplug it from the socket outlet!
– Clean the instrument with a slightly moistened cloth. You can also moisten the cloth with mild
soap suds to remove more stubborn dirt.
– If necessary, for reasons of hygiene, the attachments can be cleaned with a cloth or brush
moistened with alcohol. Dry them carefully afterwards.
– Do not drop the instrument.
– Make sure that no water enters the instrument. But if this should happen, do not use the in-
strument again until it is completely dry.
– Do not use chemical detergent or scouring agents for cleaning.
– Never immerse the instrument or plug-in power unit in water or other liquids.
5. Technical data
Power unit voltage Input:
Speed:
e – Flame milling cutter
For removing ingrowing nails. Carefully guide the flame cutter up to the
part to be treated and remove parts of the nail as necessary.
F – Sapphire milling cutter, round
This accessory attachment is for the careful removal of corns. When using
this attachment, please remember when removing the layer of skin from
the corn that you will quickly penetrate deeper into the skin and this could
injure the periosteum.
G – Needle milling cutter
The needle milling cutter is a precision tool. Please proceed cautiously
when using this attachment, since careless use can quickly cause injury.
It can be used to free ingrown nails and cut away dead nail parts. Use the
needle milling cutter at low speed.
H – Sapphire cone, long and coarse
Fast removal of thick or large calluses on the soles and heels. This attach-
ment is intended for large areas.
I – Sapphire disk, coarse
Filing and treatment of the nails, coarse grain sapphire disk. This attach-
ment allows you to shorten even thick nails by filing. Since it quickly remo-
ves large areas of the nail, you should proceed with caution in this case
also.
100-240 V AC / 50/60 Hz / 0.3 A
Output: 21 V DC / 200 mA
2600 r.p.m.–6100 r.p.m. ±12%
9