ATIKA ASP 6 L Manual Original página 26

 Adjusting the table height
Upper table plate position :
≈ 570 mm.
Middle table plate position :
≈ 820 mm.
Lower table plate position :
≈ 1035 mm.
1. Release the locking bolt.
2. Pull the table out.
3. Use the table in a position that comes close to the log
length and secure it with the locking bolt.
 Adjusting the splitting cross:
fixing
1. Loosen
screw .
2. Move the splitting
cross to the
correct position
(The fixing screw
is beyond the
borehole in the
splitting blade).
fixing
3. Mount
screw .
 Splitting short wood:
1. Upper position of table plate.
2. Place the log on the splitter's table plate.
3. Hold the log tight with the clamping claws.

Only split the logs in the direction of the wood fibres.
 Splitting long wood:
1. Middle or low
position of table or
base.
2. Remove the
splitting cross.
3. Place the log on the
splitter's table.

Possible
malfunction when
cleaving logs: The log
to be cleaved is not
cleaved right through,
jams on the cleaving
blade and is pulled up
during the blade's
return movement.
In this case, proceed
as follows:
1. Switch off the
device.
2. Depending on the
log still to be
cleaved fix the table
plate in the middle
or upper position.
3. Switch on the
device and continue
the splitting
operation.
Never try to split
two logs at once.
Never try to
remove or replace the
log during the splitting
process.
Fixing screw
Splitting cross
25