Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
WARNING
Avoid inadvertent starts: always switch the tool
off when the plug is removed from the mains
socket or if there has been a power cut.
WARNING
In continuous operation, the machine continues
running if it is forced out of your hands.
Therefore, always hold the machine with both
hands using the handles provided, stand in a
safe position and concentrate on the work.
Torque activation
Trigger
I
Switching on: Slide the trigger switch forwards and then
push the trigger switch upwards.
Switching off : Release the trigger switch.
Continuous operation
I
Switching on: Switch the machine on as described
above. Now slide the trigger switch
forwards again and release in the
front position to lock the trigger switch
(continuous operation).
Switching off : Push the trigger switch upwards and
release.
CLEANING, MAINTENANCE
Motor cleaning: The machine must be vacuumed
regularly, frequently and thoroughly through the ventilation
slots using a suitable vacuum cleaner.
The machine must be held fi rmly in this case.
Replacing the spring-mounted ring brush:
Replace worn brushes for optimal dust extraction.
Replacement brush set: Order No. 377100
10
0
Trigger
0
TROUBLESHOOTING
Machines with VTC and TC electronics: (Fig.4)
The electronic signal display lights up and the
load speed decreases. There is too much load on
the machine! Run the machine in idling until the
electronics signal indicator switches off .
The machine does not start. The electronic
signal display fl ashes. The restart protection is
active. If the mains plug is inserted with the machine
switched on, or if the power supply is restored following an
interruption, the machine does not start up. Switch the
machine off and on again.
REPAIRS
WARNING
Repairs to electrical tools must be carried out by
qualifi ed electricians ONLY!
A defective mains cable must only be replaced with a
special, original mains cable from metabo HPT, which is
available only from the metabo HPT service.
If you have metabo HPT electrical tools that require
repairs, please contact your metabo HPT service centre.
ENVIRONMENTAL PROTECTION
The sanding dust generated may contain hazardous
materials: do not dispose of this dust with household
waste, but at a special collection point for hazardous
waste.
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Tabla de contenido
