Operating Instructions; Switch On And Off - Flex WS1505FR Instrucciones De Funcionamiento

Long-necked renovation sander WS 1505FR

Operating instructions

Danger!
Before carrying out any work on the power
tool, always pull out the mains plug.
Before switching on the machine
Unpack the long-necked sander and check
that no parts are missing or damaged.
After observing the following points, insert the
plug and switch the machine on:
– Voltage:
Voltage on the rating plate equals mains
voltage.
– Switch: Machine switched off.
– Suction hose from dust extractor
connected with supplied adapter.

Switch on and off

– Switching on:
Slide the switch button on the motor
forwards, then press down.
– Switching off:
Briefly depress the back of the switch
button and release.
Attaching or changing the
grinding tool
Danger!
– Do not exceed the permitted
circumferential speed and the maximum
diameter of the diamond wheel. The
speed indicated on the diamond wheel
must not be less than the maximum
idling speed indicated on the rating
plate.
– Use the supplied clamping nut and
diamond wheels and accessories
recommended by FLEX.
1. Pull out the mains plug.
2. Place the diamond wheel centrally on
the output shaft.
3. Fold up the handle, screw on the quick-
release clamping nut and tighten firmly
by hand, then fold the handle down.
4. Check that the diamond wheel is seated
correctly.
5. Insert the mains plug into the socket.
6. Switch on the long-necked sander and
run for approx. 30 seconds. Check
for imbalances and vibrations.
7. Switch off the long-necked sander.
13